Posted 05 April 2013 - 11:25 AM
Posted 05 April 2013 - 12:26 PM
Posted 05 April 2013 - 07:21 PM
Posted 05 April 2013 - 07:38 PM
Edited by KeroPyontchi, 05 April 2013 - 07:39 PM.
Posted 05 April 2013 - 07:51 PM
I tried resetting again and hitting b to set time and the buttons are unresponsive. The ship keeps shifting left and right as per normal but nothing is happening.
Posted 05 April 2013 - 08:02 PM
Open up your Tamagotchi and rub the button contacts with rubbing alcohol and a cotton swab, then put it back together. The buttons should be fixed by then.
NOTE: You might need a teeny-tiny screwdriver to unscrew the tiny screws.
Posted 05 April 2013 - 08:04 PM
If you want to... Open it up and make sure all the lighter green paths don't have anything on them. It could be blocking the channel that sets the tama to be raise. (clock and then the tama showing up)
Posted 05 April 2013 - 08:05 PM
Posted 05 April 2013 - 08:36 PM
be careful when taking apart and putting a tama together. as thats how i ruined my p1. try not to nock the wires around!!!
Posted 06 April 2013 - 12:24 PM
I was already pro at taking tamagotchis apart because i like to know what i am dealing with. I didnt think about cleaning the rubber button inserts which was talked about. After grabbing some fine q tips (like the nice ones from the doctors, not the dual tip you can buy at grocery stores) and cleaning and drying my hands, i cleaned the circuit board and everything inside the tamagotchi. It now works. Thank you for all the help. Its been a long time sense i opened up a tamagotchi for routine maintenance.
So my opinion on what to do if your tama stops cooperating is...
If that doesnt work.....
Wash and dry hands
Fine tip q tips
CORRECT screw driver ( dont wanna warp screws )
Clean board softly
Clean rubber button insert
Clean screen ( optional taking screen apart but not necesary )
Place back together in correct order....
But as a side not, not apply rubbing alcohol to board or screen. ONLY RUBBER BUTTON INSERT.
Also make sure to completely dry the insides of the button insert/reset. If not done correctly, you could end up with a dead tama.
Again thank you everyone for reminding me of these what to dos!!!