Loganator114
Well-known member
Hello! i was talking about a tamagotchi cradle that i made from hot glue and someone asked for a tutorial
so here it is
i made this for the m!x but if you measure the sizes of yours that works just fine
so here is the template
so measure this on paper and put it unthe two parts around with hot glue and fill it up with it
wait 1-2 minute and remove repeat this again
now you will have 4 parts
see the picture how to glue togethe the big is the bottom and the back the smaller ones are the sides
and after finished it shouldlooks like this
and draw a thin line to the front with hot glue because the tama would slip off
so here it is
i made this for the m!x but if you measure the sizes of yours that works just fine
so here is the template
wait 1-2 minute and remove repeat this again
now you will have 4 parts
and after finished it shouldlooks like this
and draw a thin line to the front with hot glue because the tama would slip off
Last edited by a moderator: