HELP! HOW DO YOU GET OUT OF DEBUGGED MODE!

TamaTalk

Help Support TamaTalk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.

StrawberryStarfruit94

Well-known member
Joined
Jun 28, 2006
Messages
275
Reaction score
0
Location
Pennsylvania
ok well me and my friend debugged our tama's when our tama's died we pressed reset so it would go back to normal mode and it still came back out as the debugged egg!!! please help! i don't want anymore debugged characters unless i know how to get bacl to normal mode!! can anybody tell me how to get back to normal mode from debugged mode?

 
you can undebug it, but you just have to erase all the pencil lead from the debug circle. then it should be fine. ^_^ :ph34r:

 
Yes, just take apart your tama like you were debugging it, but instead of using the graphite end of the pencil, use the eraser! Then, you have to reset your tama and all should be back to normal.

 
After a while the lead will kinda vanish and then you will be out of debug mode. It happend to mine!

 
To get out of debugg mode you have to carefully erase all the bits of graphite (pencil lead) from your tama. When you reset it your tama should be back to normal. If not, then check to make sure you got everything off and put it back together right. Good luck! :(

\K/

 
Status
Not open for further replies.

Latest posts

Back
Top