Search the Community
Showing results for tags 'cradles'.
Found 2 results
As the Tamagotchi ON is the English counter part of the Tamagotchi Meets I was wondering if anyone here could tell me the size of the Meets. I'm planning to buy the Tamagotchi ON next month and want to make a cradle for it before I buy it if possible. But the only Tama's I have to use for size are the Connections, Music Star in terms of the most recent ones I have. My Tamago I'm sure is way to big and wide from what I've seen from reviewers who got the ON early.
I'm not to be held responsible for any damage this may cause to your Tama-Go. So you may have heard that each Tama-Go has 3 "lite" unlockable games: Cradles(wave 1), Coin Catch(wave 2) and Pattern Shoot(most likely intended for a possible wave 3). Here, on this post(http://www.kwartzlab.ca/2010/12/tamago-hacking-home-edition-ac/) by Natalie Silvanovich she explains what you have to do to to be able to do so. Here I'll post a way how to easy do this without soldering or using any wires. You will need: *A small piece of aluminum-paper *a small sheet of paper *a lite figurine UNLOCK PATTERN SHOOT(should work with a wave 2 figure as well) 1. Fold the piece of aluminum paper to a thin strip(see picture) 2.Attach the strip of aluminum over the 2 left "pins". 3.Gently slide the figure on top of the Tama-Go, making sure the piece of aluminum-paper doesn't move. Tadaa: UNLOCK COIN CATCH(wave 1): Complete the previous steps, but first attach a very small piece of paper over the left-bottom pin and only then place the aluminum over it. The goal is to make that that pin doesn't get any contact with the aluminum. That's all. Like this(X is the piece of paper, O are the pins): OOOO XOOO (IR) UNLOCK CRADLES(wave 2): I haven't tried this since I haven't got a wave 2 figure but I'm quite confident it'll work. To do this put the piece of paper on the top left pin before attaching the aluminum. Like this: XOOO OOOO (IR) Have fun!