Ok, so after i went around the house gathering supplies for surgery, I got it to work.
I was already pro at taking tamagotchis apart because i like to know what i am dealing with. I didnt think about cleaning the rubber button inserts which was talked about. After grabbing some fine q tips (like the nice ones from the doctors, not the dual tip you can buy at grocery stores) and cleaning and drying my hands, i cleaned the circuit board and everything inside the tamagotchi. It now works. Thank you for all the help. Its been a long time sense i opened up a tamagotchi for routine maintenance.
So my opinion on what to do if your tama stops cooperating is...
Reset
And/ or
Battery rotation
If that doesnt work.....
Wash and dry hands
::gloves optional::
Fine tip q tips
Rubbing alcohol
CORRECT screw driver ( dont wanna warp screws )
Clean board softly
Clean rubber button insert
Clean screen ( optional taking screen apart but not necesary )
Place back together in correct order....
Insert batteries
Reset
But as a side not, not apply rubbing alcohol to board or screen. ONLY RUBBER BUTTON INSERT.
Also make sure to completely dry the insides of the button insert/reset. If not done correctly, you could end up with a dead tama.
Again thank you everyone for reminding me of these what to dos!!!